Page 1 of 1
DVD Burning going bad or just bad disks?
Posted: Sat Sep 11, 2004 8:02 pm
by Evilone
Recently my DVD burner keeps giving write errors at the same spot on all the disks. About 40% of the way through it gives a write error. This happens about 35% of the time when im burning a DVD. The media im using is Memorex DVD-R 4x. My DVD burner does support the -R. Before this started happening I went through a whole pack of 50 memorex +R with no problems. I havn't tried another type of media yet, havn't had chance to go buy some.
Here is the info on the Drive.
Its a 4x speed and 2.4x RW
It does everything else too
Posted: Sat Sep 11, 2004 8:58 pm
by zooner
it is using a nec chipset and acer uses them as a rebadged. it says it supports dvd-r, I'll do some more research.
have you tried burning at 2x?
Posted: Sat Sep 11, 2004 9:05 pm
by zooner
have you checked for an updated firmware?
seems there are some issues with the northbridge and this burner? Esp running with a sis chipset.
what's the buffer showing before you hit that dreaded 40%
Posted: Sat Sep 11, 2004 11:38 pm
by Evilone
ok just did a burn, failed... 32% done of 4.3 gigs
buffer was at 93%. that was a 4x speed, im going to try one now at 2x speed.
Posted: Sat Sep 11, 2004 11:51 pm
by Evilone
the 2x speed failed too at exactly 32% again buffer at 95%
i believe its the drive...
Posted: Sun Sep 12, 2004 12:49 pm
by Jim
Pick up a single disc of another type of media, just to check. My burner started giving me errors, also after burning many spindles without a hitch. Despite the fact that the firmware was up to date, certain spindles of discs seem to give my burner trouble. I picked up a second one, just in case, and it worked fine. Got the spindle replaced, and it worked fine again.
I see no rhyme or reason why that would be the case, but it has happened to me.