ICS woes

[WhiteMountains]

Ill try to make this as short as possible> client cannot connect to internet. Host and client can ping each other and read each others drives without netbui although host has to be connected to the internet. heres my details;
Host winipcfg; IP routing enabled everything else is blank,ip 192.168.0.1, mask 255.255.255.0
Client winipcfg; all blank except for the following ; IP 192.168.0.2, mask 255.255.255.0, default gateway 192.168.0.1, DHCP server 192.168.0.1
Host Network; client for MS,D-link adapter,Dial up adapter,IC sharing adapter,IC sharing protocol>D-link,IC sharing protocol Dial up adapter, IC sharing protocol IC sharing, TCP/IP home>D-link,TCP/IP shared dial up adapter, TCP/IP IC sharing, file + print sharing.
Client Network; Client for MS, D-Link adapter, TCP/IP, file + print sharing.
Host is 98SE,Client is 98,Hub is D-link neway,cat 5 cable.
Other factors, Host> D-link adapter bound to ICS protocol and TCP/IP home TCP/IP home bound to Client for MS and file + print sharing,TCP/IP shared bound to Client for MS and File + print sharing
Client >D-link adapter bound to TCP/IP, TCP/IP bound to client for MS and file and print sharing.
I am aware of way too many protocols on the host but this should show the difficulty Ive run into trying to get my client on the net , lol. BTW,I did not install the WOL cables yet but I think thats irrelavent at this time right?
Ne help will be greatly appreciated.

[Zporttech]

My suggestion would be to drop the ICS and get yourself a good router. You will find things allot smoother.

[YeOldeStonecat]

While I prefer a router also, ICS still works, and he needs help getting it working.

Here's a little readme just to review.
http://www.annoyances.org/exec/show/ics_98#2a

[WhiteMountains]

WOW this is a tough nut to crack, I followed the instructions on that page to the letter and I lost my ping,my intranet and I only have shared dial up adapter on winipcfg now. I guess I gotta do everything over again?