SG Broadband Community

Same here....no luck! Windows 98SE...As soon as I copied the files from the Ramdrive back to System directory, everything was OK!

AlphaIVT,

I've been posting my results on Anandtech with the same problem as you (In General Hardware forum). I was having the same problem with the 1.33.1 and 1.34 Firmwares...I've downgraded to the 1.30 version and I've been running over 5 days now with no resets. This is very encouraging ...

Didn't see this posted, but ZoneAlarm 2.1 is out. It is not detected as an upgrade by the previous version of ZA. It adds logging of intruders.

Get it at:

www.zonelabs.com

Regards

RF

Same here! I installed the upgrade last night and, at first, everything was great. I like the new firmware better than any of the past. Anyway, webpages and ftp would start and last about 30 seconds (faster throughput than normal though??) and then just stop. Had to reset the linksys (and sometimes ...

QUOTE:

3% of the routers will experience packet loss due to heat problems at high usage and router life without cooling is estimated at 5 years with constant use

You'll get a new one before the 5 year period is up!

Shame, Shame......

RF

When you are being pinged with the router, the main IP address is being pinged and the router is responding. Your internal IP address is not being pinged (unless your machine is on the DMZ and all ports are being forwarded to you) because of NAT routing. ZoneAlarm would be great if running on the ...

Just Ignore this

Regards

RF

[This message has been edited by Engineer (edited 03-10-2000).]

I think the Linksys router itself will respond to pings. I have used both Both BlackIce and ZoneAlarm with and without the router. Without the router, I get a clean bill of health (Stealth on all counts). With the router, I get (GRC) ports closed and on Secure-Me net, I get a score of -0 instead of ...

StanFL,

Did you enter your ISP domain name on the router setup home page? That took care of the problem with @home using NEWS and MAIL for the names of the servers for news and mail. It will also take care of using WWW/ to access the @home page.

(Oh, I'm just assuming you are using @home. If not ...

I tried to install the @home network test software from the CD, but it would start then abort with no message. Anyone else with this? If so, can it be solved?

Thanks

RF

Insight@home in Lexington, KY
fran073@home.com